教学文库网 - 权威文档分享云平台
您的当前位置:首页 > 文库大全 > 求职职场 >

大管轮轮机英语综合(33-48期)(10)

来源:网络收集 时间:2026-04-09
导读: one of the following statements is incorrect ? A. Only one pump should be used at any time B. The ship speed should be reduced to 70% of the normal C. Watch keeping of the steering gear should be inc

one of the following statements is incorrect ? A. Only one pump should be used at any time

B. The ship speed should be reduced to 70% of the normal C. Watch keeping of the steering gear should be increased

D. Limitations of the steering gear should be logged but the bridge need not be informed

大管轮轮机英语综合

30. Which of the following problems could cause air to blow out through the inlet air filter of a

running compressor?

A. Excessive compression in the cylinder B. A broken intake valve

C. A dirty inlet filter element D. An improperly adjusted discharge valve

31. When a refrigeration compressor is in the 'off' cycle, the thermal expansion valve will ______.

A. always be wide open when the compressor restarts B. continue to operate as if the system were in operation

C. remain open until evaporator pressure equalizes, then close until the compressor restarts D. always be completely closed until the compressor restarts

32. An increasing head pressure in a refrigeration system, without any corresponding change in the

cooling water inlet temperature, would probably be caused by ______. A. restriction in refrigerant piping

B. air and non-condensable gases in the condenser C. water in the refrigerant

D. flooding back of liquid refrigerant from the evaporator

33. In a refrigeration system, if the cooling water to the condenser fails, the ______.

A. box temperature solenoid valve will close B. expansion valve will close C. compressor will shutdown D. king valve will open

34. The basic training in fire prevention and fire fighting should include the theoretical elements

which should cover ______.

A. the three elements of fire and explosion B. lower and upper flammable limits

C. classification of fires and applicable extinguishing agents D. all of the above

35. Sacrificial zinc anodes are used on the saltwater side of diesel engine heat exchangers to ______.

A. reduce electrolytic action on heat exchanger metals B. keep heat transfer surfaces shiny and clean C. prevent rapid accumulation of marine growth

D. provide a protective coating on heat exchanger surfaces

36. To parallel an incoming machine to a running machine therefore it is necessary to ensure firstly

that ______.

A. two frequencies must be brought into phase

B. the incoming machine accepts a small amount of load C. the running machine must be unload D. both voltages are equal

37. Self-excited a.c. generator with error operated voltage control systems draw the full excitation

power for the machine terminals. This dispenses with the current transformers, reactors and capacitors necessary for accurate compounding, but renders the excitation system vulnerable to variations in its output voltage. Which of the following is correct about the generator mentioned according to the sentences above?

A. It consumes no excitation power. B. It has current transformers.

C. Components are needed for accurate compounding. D. Its excitation system is vulnerable to voltage variations

38. Which of the following should be the FIRST step in removing a generator from parallel operation?

A. Trip the generator off the switchboard. B. Turn off all electrical equipment.

C. Remove the load from the 'off going' generator.

D. Increase the cycles of the generator staying on the line.

39. This arrangement is ______if the elements are directly connected to one another and the control

action takes place without human involvement.

A. a manual closed loop B. a manual opened loop C. an automatic closed loop D. an automatic opened loop

40. The viscosity regulator controls the fuel oil temperature ______provide oil at the correct viscosity

for combustion.

A. in order that B. because of C. in order to D. owing to

41. ______is a precaution which contributes to avoiding trouble under normal operating conditions.

A. Constant inspection B. Keeping constant load C. Remaining constant temperature D. varying speed

42. To repair a small electrical motor that has been submerged in saltwater, you should ______.

A. wash it with fresh water and apply an external source of heat B. renew the windings

C. send it ashore to an approved service facility

D. rinse all electrical parts with a carbon tetrachloride cleaning solvent and then blow dry the motor with compressed air

43. The diesel engine consumes considerably less fuel than the steam engine for equal output,

______enables a motor-ship to load more cargo.

A. why B. which C. in which D. on which

44. The conclusion that mechanical efficiency is always ______100 per cent is correct.

A. small than B. more than C. little than D. less than

45. The diesel engine valve subjected to most severe conditions of service is the ______.

A. cylinder exhaust valve B. air starting valve C. air inlet valve D. cylinder relief valve 46. One cylinder of a diesel engine is persistently knocking and does not cease when the fuel supply

to that cylinder is secured. Which of the following problems may be the cause? A. Low loading of the cylinder. B. Excessive cooling of that piston.

C. Sluggish ring action on the piston. D. A mechanical defect in a working part.

47. A diesel engine is operating with excessively high exhaust temperatures at all cylinders. To

correct this condition, you should first ______.

A. reduce the engine load B. increase the cooling water flow C. increase the lube oil pressure D …… 此处隐藏:5193字,全部文档内容请下载后查看。喜欢就下载吧 ……

大管轮轮机英语综合(33-48期)(10).doc 将本文的Word文档下载到电脑,方便复制、编辑、收藏和打印
本文链接:https://www.jiaowen.net/wenku/119726.html(转载请注明文章来源)
Copyright © 2020-2025 教文网 版权所有
声明 :本网站尊重并保护知识产权,根据《信息网络传播权保护条例》,如果我们转载的作品侵犯了您的权利,请在一个月内通知我们,我们会及时删除。
客服QQ:78024566 邮箱:78024566@qq.com
苏ICP备19068818号-2
Top
× 游客快捷下载通道(下载后可以自由复制和排版)
VIP包月下载
特价:29 元/月 原价:99元
低至 0.3 元/份 每月下载150
全站内容免费自由复制
VIP包月下载
特价:29 元/月 原价:99元
低至 0.3 元/份 每月下载150
全站内容免费自由复制
注:下载文档有可能出现无法下载或内容有问题,请联系客服协助您处理。
× 常见问题(客服时间:周一到周五 9:30-18:00)